CH-640 Fuselage Front Z and torque tube tunnel (49 of 70)
![[First]](../images/bl_first.gif)
|
![[Prev]](../images/bl_prev.gif)
|
![[Home]](../images/bl_home.gif)
|
![[Index]](../images/bl_index.gif)
|
![[Next]](../images/bl_next.gif)
|
![[Last]](../images/bl_last.gif)
|
|
| Cut two standard L's 250mm long. Position L's to rear of front Z, drill and cleco in place A4 P35. Make sure that you do not drill where the floor support will be located on the front of the front Z. This was between the second and third rivet hole from the bottom on mine so I was able to drill all my holes. |
|
|
|
|
|
|
|